Computer Controlled Axial Flow Turbine- Engineering Lab Training Systems Description and Specifications for Lab Tenders
EXERCISES AND PRACTICAL POSSIBILITIES
Some Practical Possibilities of the Unit:
1.-Determination of the nozzle discharge coefficient.
2.-Determination of operating characteristics of the Axial Turbine at different speed values (20º nozzle).
3.-Determination of operating characteristics of the Axial Turbine at different speed values (30º nozzle).
4.-Determination of the Axial Turbine characteristic curves (20º nozzle).
5.-Determination of the Axial Turbine characteristic curves (30º nozzle).
6.-Determination of torque, efficiency and power curves at a constant value (20º nozzle).
7.-Determination of torque, efficiency and power curves at a constant value (30º nozzle).
8.-Determination of curves in relation to the turning speed (20º nozzle).
9.-Determination of curves in relation to the turning speed (30º nozzle).
10.-Determination of curves in relation to the flow (20º nozzle).
11.-Determination of curves in relation to the flow (30º nozzle).
12.-Adimensionalization.
13.-Flow calculation.
Other possible practices:
14.-Pressure Sensors Calibration.
15.-Flow Sensor Calibration.
Practices to be done by PLC Module (PLC-PI)+PLC Control Software:
16.-Control of the TFAC unit process through the control interface box without the computer.
17.-Visualization of all the sensors values used in the TFAC unit process.
18.-Calibration of all sensors included in the TFAC unit process.
19.-Hand on of all the actuators involved in the TFAC unit process.
20.-Realization
of different experiments, in automatic way, without having in front the
unit. (This experiment can be decided previously).
21.-Simulation
of outside actions, in the cases do not exist hardware elements.
(Example: test of complementary tanks, complementary industrial
environment to the process to be studied, etc).
22.-PLC hardware general use and manipulation.
23.-PLC process application for TFAC unit.
24.-PLC structure.
25.-PLC inputs and outputs configuration.
26.-PLC configuration possibilities.
27.-PLC program languages.
28.-PLC different programming standard languages.
29.-New configuration and development of new process.
30.-Hand on an established process.
31-To visualize and see the results and to make comparisons with the TFAC unit process.
32.-Possibility of creating new process in relation with the TFAC unit.
33.-PLC Programming Exercises.
34.-Own PLC applications in accordance with teacher and student requirements. Fluid Mechanics Lab Equipments manufacturers.