Toyota Corolla Electrical Controlled Engine Description and Specifications for Lab Tenders
Toyota Corolla Electrical Controlled Engine (Transmission and Air conditioning) Comprehensive Training Workbench.
Introduction
The training workbench adopts Toyota Corolla electrical controlled
gasoline engine assembly, transmission assembly, air condition assembly.
With complete accessories, can be used to complete various training
Content of engine load. All components adopt original parts, QC strictly
testified, in accordance with Production Quality Management standard of
ISO9001:2008, suit for car engine structure and maintenance practical
training in the medium and senior vocational schools and car training
institutions, satisfy the requirement of teaching training project on
the electronic controlled engine / transmission / Air-conditioning
system structure, working principle, fault diagnosis, fault setting and
exclusion assessment.
Basic Configuration
Engine assembly, transmission assembly, air-conditioning assembly,
engine control unit and transmission control unit, engine circuit plug,
combination instrument , training panel, diagnostic block, tank
assembly, up and down pipe, Kettle, thermostat switch, cooling fan
assembly and bracket, fuel pressure gauge, vacuum gauge, ignition
switch, battery, starter, generator , fuel pump assembly, fuel filter,
air filter, Ignition key with a chip, anti-theft Identification coil,
intake and exhaust manifolds, catalytic assembly, central console, oil
tank, movable bench and mobile casters, general power switch, relay and fuse box etc.
Features
Demonstrate the engine /transmission /air-conditioning system work, run
smoothly, actually reflect EFI gasoline engine structure and working
principle.
Demonstrate engine oil pressure, vacuum pressure, oil pressure normal
operating pressure.
Equipped with digit display meter to display the related sensor working
static value and dynamic value.
Equipped with colorful electronic engine control system schematics and
detection terminal, through a variety of professional instruments to
detect the signal parameters of sensors, actuators etc. such as voltage,
resistance, frequency etc.
Testing the automatic transmission stall and delay.
Operation like Vacuum, filling the refrigerant, leak detection etc.
Equipped with diagnostic blocks can be connected to a dedicated or
general-auto decoders, to complete reading fault codes of engine
electronic control system, clearing fault codes, reading data stream,
matching adjustment, programming, testing, testing terminal components
etc engine diagnostic function.
Fault setting and assessment system (please refer to the detailed
function introduction of fault setting and assessment).
Rotate position of training sets are equipped with safety shields to
keep safe.
Equipped with extinguisher and short circuit power off self-protection
device.
With locking casters for mobile devices, easy to move for teaching.
Training Content
Engine with transmission, air-conditioning system structure and
composition training.
Each assembly component setup position training.
Each assembly sensor voltage, resistance, signal testing training.
Engine fuel pressure, Vacuum pressure, oil pressure training.
Air-conditioning system vacuum, filling the refrigerant, leak detection
operation training.
Automatic transmission stall and delay training.
Schematics analysis training.
Engine control unit fault code reading，fault code eliminate, data flow
reading, Anti-theft matching adjustment, programming, terminal component
testing training.
Each assembly troubleshooting and confirm training.
Each assembly fault setting and exclusion training.
Each assembly practical operation and theoretical exam training.
Technique Parameter
Engine Model
Engine Location Front
Engine type1.8
Number of cylinders4
Displacement 1.798L
Valve structure dual overhead cam (DOHC)
Fuel type unleaded gasoline 90
Compression ratio10:1
Maximum torque173Nm
Maximum torque speed 6400rpm
Input voltage AC 220V
Power supply DC 12V
Battery capacity60HA
Fuel tank capacity 12L
The fuel
Operating temperature-40 ℃ ~ + 50 ℃
Dimensions1650×850×1800mm(L×W×H)
Test bench size1500×850×1850mm(L×W×H)